Bill’s Playbook · George’s quick start
2014 Ram ProMaster 3.0L diesel: accumulator swap
M40/MTA automated manual · Quick start, one page · Full guide with sources and the scanner helper: billsplaybook.info
Up to about 1,100 psi. Never loosen the accumulator to let the pressure out. Scanner depressurization first, then ignition off, then unplug the pump.
Before you start: all of these, or don’t start
- Ram dealer, with Bill’s VIN (3C6URVHD9EE130571): 68133085AA fits this van? Comes with an O-ring? And get the accumulator torque. We don’t print one because no public source we found has it.
- 2 quarts Mopar 68092638AC (C Series DDCT 75W hydraulic fluid), plus a clean funnel or syringe.
- Scanner: AlfaOBD full version + OBDLink LX + the yellow adapter. Backup: a dealer wiTECH, or Snap-on (check it shows the bleed).
- On this van, the scanner shows all four: Hydraulic Circuit Depressurization, Bleed Hydraulic Circuit, Reset of Data Group, Quick Learn. If one is missing, stop.
- Battery maintainer on any time the scanner is running. Measure the hex on the new accumulator (owners report 22 or 27 mm).
Fluid: cap 2 only. Mopar 68092638AC, filled to the middle of the sight window with the pressure released. Don’t use the lowest mark; that’s the running level under pressure. Never DOT 4 or ATF in cap 2. Cap 1 right beside it is the DOT 4 clutch fluid, so don’t open it. Leave the gearbox oil alone.
The job
- Parking brake on, wheels chocked. Engine off, ignition ON. Scanner: Hydraulic Circuit Depressurization. Photograph any transmission codes first. Wait until it says complete. If it fails, stop.
- Ignition OFF. Unplug the pump connector (“Selespeed Pump”) right away. Owners report the pump recharges when a door opens.
- Battery negative off. Take the battery and battery box out of the floor at the driver’s feet. Photograph the cables first.
- Van on jack stands. From underneath on the driver’s side, find the round canister with a hex on the pump unit. That’s the accumulator. Ducato owners (same van, same transmission) got to it this way; nobody has published it for a ProMaster. Can’t get a socket on it? Stop and send Bill a photo.
- Pump still unplugged? Eye protection on. Clean around it, catch pan under, then unscrew it. It can be very tight; hold the unit so the lines don’t strain. Old and new side by side: same thread, same seal. New O-ring, wiped with the 75W fluid.
- Start it by hand. Torque to the dealer’s number.
- Pump still unplugged: fill cap 2 to the middle of the window.
- Pump connector back in with the ignition off. Battery box and battery in, positive first. Maintainer back on.
- Ignition ON, engine off. Scanner: Bleed Hydraulic Circuit, then command the pump on and let it pressurize. Look for leaks. Check cap 2: lower under pressure is normal. To top up, release the pressure first.
- Scanner: Reset of Data Group, then Quick Learn. If the scanner asks for a different order, follow the scanner. Skip New Actuators and Learn Clutches Contact Point.
- Van back on the ground. Start the engine and run it until the scanner’s Transmission Temperature reads HOT. Read codes and clear only the ones from the repair. On the brake, try R, N and D. Then road test through every gear.
- Back at the shop: recheck cap 2, rescan and look for leaks. The pump shouldn’t keep cycling with the van parked.
The old accumulator still holds nitrogen, so don’t drill it or heat it. Anything doesn’t match the van? Stop and send Bill a photo. Sources and details: billsplaybook.info.